پوشش کنوسا MIS-65 / MIS-100

MIS-65 / MIS-100

Wraparound Sleeve for Offshore Heated Infill Systems

Product Description

Corrosion Protection of Girth-

Welds under heated infill systems

on offshore service environments

MIS-65 and MIS-100 heat-shrinkable

sleeves provide superior corrosion

protection and effective long-term

adhesion to pipelines operating offshore at

temperatures up to 100°C (212°F). MIS-65

and MIS-100 sleeves are specifically

engineered for use in combination with hot

marine mastic pour, polyurethane foam or

other infill systems. MIS-65 and MIS-100

sleeves are resistant to the severe

conditions of hot mastic pour operations

and maintain their full set of anti-corrosion

properties. MIS-65 and MIS-100 are fully

compatible with a wide range of pipeline

coatings, including PP, FBE, PE, Coal Tar and

Tape.

Flexible & Time Efficient

Installation

MIS-65 and MIS-100

sleeves have a

patented one-piece construction that

incorporates a pre-attached closure seal.

This contributes to a rapid and consistent

field installation procedure. Without any

requirements for the wrapping of multiple

layers, the field installation is fast, efficient

and in-line with timing requirements of

offshore laybarge operations. The

crosslinked high-density polyethylene

(HDPE) backing is designed to provide a

rapid and consistent shrink response when

installed with propane torch equipment

MIS-65 and MIS-100

sleeves can be

conveniently wrapped and installed in low

ambient temperatures due to its excellent

low temperature flexibility attributes

Unique Adhesive Technology

MIS-65 and MIS-100

MIS-65

and MIS-100

MIS-65 and MIS-100

Maximize Cost Savings

Canusa's unique (open time) adhesive

technology allows for lower installation

preheat temperatures, superior adhesion to

a wide range of mainline pipe coatings and

consistent performance in rugged offshore

environments. The adhesive has been

formulated to provide long-term adhesion

and excellent cathodic disbondment

resistance properties

Hot Mastic & Foam Infill

Compatibility

sleeves can be used

with hot mastic pour, polyurethane foam or

other infill systems to provide effective

long-term corrosion protection.

sleeves are resistant to hot

mastic pour systems and meet the

requirements of the Drum Skin Test for

high temperature effects

Maximize Cost Savings

Canusa's unique (open time) adhesive

technology allows for lower installation

preheat temperatures, superior adhesion to

a wide range of mainline pipe coatings and

consistent performance in rugged offshore

environments. The adhesive has been

formulated to provide long-term adhesion

and excellent cathodic disbondment

resistance properties