لودسل CNX-50 شرکت BCS

شرکت بی سی اس (BCS Italia) ​​در زمینه ترازوهای الکترونیکی و سیستم های تشخیص نیرو، سنسورهای فشاری، کششی، خمشی و ... طراحی و تولید می کند. که در صنایع آهن و فولاد ، کارخانه کشتی سازی و بنادر ، مکانیک و ماشین ابزار ، مواد شیمیایی و پتروشیمی ، کاغذ ، انرژی ، حمل و نقل کاربرد دارند.
لودسل CNX-50 شرکت BCS دارای بار نامی 50 تن است.

compression load cell

Compression load cells can be used for oscillating mounting systems (or sliding bearing) or with double spherical shells and hardened dowels. Compression load cells can be empoyed in mounting systems (or sliding ball bearing) or with double spherical head and hardened blocks.

BCS compression load cells series CN is very compact, rugged transducers, without movable parts,
suitable to convert supported forces or weights into a proportional electric signal.
Load cells consist of an elastic mechanical element in high tensile steel withstanding the load, activated by
means of a full strain-gauges bridge.
Proper and accurate thermal compensation for zero coefficient and elastic module of the supporting
element steel allows measuring strain and weights in a wide room temperature range, with reliability, high
accuracy and repeatability over the short and long term.
Each load cell is calibrated for an output signal of 2,000 mV/V at nominal rated load applied: this allows
complete interchangeability among load cells, without any calibration adjustment for the connected
measuring instrument.
Each cell is closed into a waterproof case and is provided with 5 m of six-wire shielded cable, directly
fastened to the case (for some applications, a special cable for a high-temperature environment is available).
On request, the cable can be replaced by a 6-pin connector.
Load cells series CN has been specifically designed to cope with side loads, and are provided with a double
spherical head, which allows moderate slope of load cell with inherent small side loads and assures the
settlement in a vertical position when the sideload falls; the use of relevant mounting accessories (hardened
steel pads and mounting plates) is recommended.
The following nominal capacities are available: 6 - 10 - 15 - 20 - 30 - 50 - 100 - 150 - 200 tons; on request,
load cells with other capacity values can be manufactured.